Enjoy Free Shipping on all orders over $35!

Road Legends

1. The first rule is that if the rules do not specifically state that you
can do something, YOU CANNOT DO IT.
2. Absolutely no changes to the configuration of the chassis or cutting on
the chassis parts. No replacement parts of graphite or other higher tech
3. Any location of receiver and speed control on top of the battery plate is
Allowed. Steering servo may be mounted on the front axle plate, or under
the long battery tray. (Mounting the servo to the chassis with screws is permitted)
4. No changes in the steering blocks, axle, or springs. Shims are allowed
on springs to stiffen front ends. May also add the front kingpin brace
( 5240) to help prevent front axle breakage in severe wrecks. You may
put a washer behind the e-clip on the front axle to stop it from pulling thru
the steering block.
5. Original front steering rods can be bent as needed, if the steering servo
is mounted on the front axle plate. Double lock collars are allowed on each
side of the steering linkage to prevent slippage.
6. Factory front bumper must remain on the car.
7. No ball bearings allowed anywhere on the car, except inside servos. No
modifications to the oilite bushings in any way.
8. No changes allowed to rear axle or differential. No ceramic or carbide
diff balls or drive rings allowed. No 64 pitch gears– must use original
type 81 tooth 48 pitch diff gear . No lightweight rear axles. No thrust
bearings allowed, except one in the diff assembly. Steel pinions only.
9. You may change the left side (setscrew) hub to 5313 nylon/aluminum
Hybrid hub only, or use 1/4 “ spacer on the left side with the original
5311 hub, and 5309 narrow diff hub to narrow the rear track. Reducing
the track width of the car can increase rear traction if needed.
10. Only genuine R/C LEGENDS bodies are allowed as replacements
NO changes allowed from trim lines, except for 1/4 “ tolerance around
Body must be painted & all windows clear or cut out. It is legal to reinforce
the inside of the body where the side posts go thru with tape or
scrap lexan from the wheel cutouts.
11. No rollover or stiff antennas allowed. Antenna may be mounted inside
the body for small tracks where radio range is not a problem.
12. Only Legends kit tires or legends/spec tires on factory
wheels are allowed.
13. Tires must be mounted in the direction shown in the kit instructions
( No reversing front tires).
14. The only 2 permitted motors are the Duratrax Photon 2 20T Brushed Motor (DTXC3301) and Dynamite 20T Brushed Motor (DYN1171)
14b. RJS5248 Legends motor heat sink is allowed. Keeps the motor running
cooler and last longer.
15. Battery pack must remain in the stock location, down the center of
the chassis between the frame rails. SMC 4000 or 4300 Spec Pack only. Max starting voltage at race time is 4.2V
16. Must use original equip. pinion gear (21 or 22 tooth 48 pitch STEEL)
17. RJS5246 3pc. Front Axle Plate is Legal
18. RJS5250 Linkage Kit is Legal
19. REVERSE: not allowed
20. Minimum Weight: 34oz
21. All weight must be contained within the chassis
22. Chassis & Car Dimensions must be within the following ranges:
-Wheelbase: 9.3 - 9.4"
-Front Width: Maximum 8"
-Rear Width: 7.875 - 8.375"
-Roof Height: Minimum 5" from ground
-Front Tire Width: 1.1 - 1.25"
-Rear Tire Width: 1.9 - 2.1"
-Maximum Tire Diameter: 2.4"
23. Motor must remain sealed.  Absolutely no tampering with the motor.
24. Legal Bodies:
-RJS1016 '34 Coupe
-RJS1017 '37 Sedan
-RJS1018 '40 Coupe
-RJS1035 '34 Sedan
-RJS1036 '37F Coupe
-RJS1044 '37F Sedan
-RJS1045 '37C Coupe
-RJS1046 '37D Coupe
-BL 2244 '34F Coupe
-BL 2267 '37D Coupe
-BL 2270 '34F Sedan
-BL 2290 '37C Coupe
-BL 2291 '37F Sedan
-BL 2294 '37F Coupe
-BL 2295 '37C Sedan
-BL 2296 '40F Coupe